| ACTUATION METHOD | DIRECT |
| BLEEDING FEATURE QUANTITY | 1 |
| BODY OUTSIDE DIAMETER | 1.840 INCHES MAXIMUM |
| COMPRESSED LENGTH | 11.500 INCHES NOMINAL |
| EXTENDED LENGTH | 13.000 INCHES NOMINAL |
| FIRST END OUTSIDE DIAMETER | 0.770 INCHES MINIMUM AND 0.830 INCHES MAXIMUM ALL WORKING ENDS |
| FIRST END HOLE DIAMETER | 0.2495 INCHES MINIMUM AND 0.2500 INCHES MAXIMUM ALL WORKING ENDS |
| FIRST END THICKNESS AT MOUNTING HOLES | 0.432 INCHES MINIMUM AND 0.437 INCHES MAXIMUM ALL WORKING ENDS |
| FIRST PISTON ROD END STYLE | BEARING TYPE ALL WORKING ENDS |
| OVERALL DIAMETER | 1.940 INCHES NOMINAL |
| MATERIAL | ALUMINUM ALLOY 356.0 BODY |
| MOUNTING FACILITY DIAMETER | 0.2495 INCHES MINIMUM AND 0.2500 INCHES MAXIMUM |
| MOUNTING FACILITY LENGTH | 1.440 INCHES NOMINAL |
| MOUNTING PROVISION | PIN |
| MOUNTING TYPE AND LOCATION | TONGUE CYLINDER HEAD END |
| PORT LOCATION AND QUANTITY | 1 PISTON ROD END AND 2 CENTER SECTION |
| PORT STYLE | GASKET SEAL SINGLE PORT |
| PORT THREAD CLASS | 3B SINGLE PORT |
| PORT THREAD DIAMETER | 0.438 INCHES NOMINAL SINGLE PORT |
| PORT THREAD QUANTITY PER INCH | 20 SINGLE PORT |
| PORT THREAD SERIES DESIGNATOR | UNF SINGLE PORT |
| REFERENCE NUMBER DIFFERENTIATING CHARACTERISTICS | AS DIFFERENTIATED BY SOURCE CONTROL DWG NO. 114HS105 FSCM 77272 |
| RESERVOIR TYPE | REMOTE |
| SEAT ANGLE IN DEG | 45.0 SINGLE PORT |
| STRAIGHT BORE INSIDE DIAMETER | 1.188 INCHES MINIMUM AND 1.520 INCHES MAXIMUM |
| TEMP RATING | -65.0 FAHRENHEIT AND 275.0 FAHRENHEIT |
| TEST DATA DOCUMENT | 77272-114HS105 DRAWING (THIS IS THE BASIC GOVERNING DRAWING, SUCH AS A CONTRACTOR DRAWING, ORIGINAL EQUIPMENT MANUFACTURER DRAWING, ETC.; EXCLUDES ANY SPECIFICATION, STANDARD OR OTHER DOCUMENT THAT MAY BE REFERENCED IN A BASIC GOVERNING DRAWING) |