|
|
|
National Stock Number:
3040-00-083-4466
Federal Supply Class:
3040
National Item Identification Number:
000834466
Description:
SHAFT,SHOULDERED
Detail:
A shaft having two or more different diameters (greater than 0.031 inches (0.79 millimeter)) along its length. It must have one or more of the following conditions: a specified surface finish designation in the range 1 to 125 microinches (0.025 to 3.2 micrometers) arithmetical average (AA), machined peripheral flat(s), circular groove(s), keyway(s), splines, threads, or holes. The ends and/or shoulders may be machined to accommodate bearings, couplings, and the like. It is not designed for use in aligning by fitting into corresponding holes of another item. For items used to support rotating members see AXLE(1), SHOULDERED. For items not having any of the above conditions see PIN, SHOULDER, HEADLESS. Excludes SHAFT(1), STRAIGHT; and AXLE(1), STRAIGHT.
|
Manufacturer Information:
| 584188 | 22907 | HELIGEAR ACQUISITION CO. |
|
Techincal Specification:
| END SIMILARITY | NOT IDENTICAL | | FIRST END DIAMETER | 0.3160 INCHES NOMINAL | | FIRST END PITCH DIAMETER | 0.3020 INCHES NOMINAL | | FIRST END WIDTH ACROSS FLATS | 0.2500 INCHES NOMINAL | | FIRST END STEP LENGTH | 0.3300 INCHES NOMINAL | | FIRST END STYLE | SQUARE (ROUND CORNERS) | | FSC APPLICATION DATA | ACTUATOR AIRCRAFT | | LARGEST STEP DIAMETER | 0.352 INCHES NOMINAL | | OVERALL LENGTH | 6.640 INCHES NOMINAL | | MATERIAL DOCUMENT AND CLASSIFICATION | MIL-S-5626 MIL SPEC SINGLE MATERIAL RESPONSE | | MATERIAL | STEEL COMP 4140 | | SECOND END DIAMETER | 0.3438 INCHES NOMINAL | | SECOND END SPLINE MINOR DIAMETER | 0.2706 INCHES NOMINAL | | SECOND END SPLINE QUANTITY | 10 | | SECOND END STYLE | SPLINED (INVOLUTE) | | SECOND END PRESSURE ANGLE | 30.0000 DEGREES NOMINAL | | SECOND END SPLINE LENGTH | 0.5000 INCHES NOMINAL | | SECOND END SPLINE MAJOR DIAMETER | 0.3438 INCHES NOMINAL | | STEP QUANTITY | 4 | | SURFACE FINISH | 125.0 MICROINCHES |
|
|