5365-00-062-2333 SHIM SET Index 7490-00-062-2336 CLIP,TYPE HOLDER

National Stock Number:
5310-00-062-2334

Federal Supply Class:
5310

National Item Identification Number:
000622334

Description:
WASHER,FLAT

Detail:
A washer having a centrally located hole with a solid or laminated cross-section and two flat parallel bearing surfaces. The hole must be 75 percent or less than the largest dimension and the bearing surface finish is greater than 32 microinch (0.8 micrometer). The thickness cannot exceed 25 percent of the largest outside dimension. When the largest outside dimension is less than 1/4 inch or 6mm, the thickness must be 0.006 inches (0.15mm) or greater and for items 1/4 inch (6mm) or larger, the thickness must be 0.016 inches (0.4mm) or greater. The maximum tolerance is applied to dimensions and used as a determining factor. Items with separable lamination use SHIM. For items fabricated from ceramic or electrically rated materials by specification or industry standards use INSULATOR (1), WASHER. Excludes DISK, VALVE, graphite impregnated and lubricated items.


Manufacturer Information:
9937A513002GOODRICH CORPORATION
9937A56K4C8GOODRICH CORPORATION


Techincal Specification:
SURFACE TREATMENTCADMIUM OVERALL
THICKNESS0.124 INCHES MINIMUM AND 0.125 INCHES MAXIMUM
CENTER HOLE SHAPE STYLEROUND
CROSS-SECTIONAL SHAPE STYLERECTANGULAR
HARDNESS RATING34.0 ROCKWELL C MINIMUM AND 39.0 ROCKWELL C MAXIMUM
HOLE DIAMETER0.890 INCHES NOMINAL
OVERALL DIAMETER1.500 INCHES NOMINAL
MATERIAL DOCUMENT AND CLASSIFICATIONMIL-T-6736,TY 1 MIL SPEC SINGLE MATERIAL RESPONSE OVERALL
MATERIALSTEEL COMP 4130 OVERALL
PERIPHERAL SHAPE STYLEROUND
SURFACE FINISH63.0 MICROINCHES ALL SURFACES


Click here to Register for Free 30-day Trial