| ELECTRICAL RESISTANCE PER SECTION | 10.0 KILOHMS SINGLE SECTION |
| ACTUATOR TRAVEL CONTROL FEATURE | CLUTCH |
| ACTUATOR TYPE | SINGLE SHAFT |
| AMBIENT TEMP IN DEG CELSIUS PER SECTION AT FULL RATED POWER | 50.0 SINGLE SECTION |
| AMBIENT TEMP IN DEG CELSIUS PER SECTION AT ZERO PERCENT RATED POWER | 135.0 SINGLE SECTION |
| BODY HEIGHT | 0.330 INCHES MAXIMUM |
| BODY LENGTH | 1.235 INCHES MINIMUM AND 1.265 INCHES MAXIMUM |
| BODY STYLE | RECTANGULAR W/MOUNTING HOLES/SLOTS |
| BODY WIDTH | 0.235 INCHES MINIMUM AND 0.265 INCHES MAXIMUM |
| CENTER TO CENTER DISTANCE BETWEEN CENTER TERMINAL AND OUTSIDE TERMINAL | 0.248 INCHES MINIMUM AND 0.316 INCHES MAXIMUM |
| CENTER TO CENTER DISTANCE BETWEEN TERMINALS | 0.690 INCHES MINIMUM AND 0.710 INCHES MAXIMUM |
| CENTER TO CENTER DISTANCE BETWEEN TERMINAL ROWS | 0.090 INCHES NOMINAL |
| CONTACT ARM ELECTRICAL OFF POSITION | FULLY CCW |
| LATERAL DISTANCE BETWEEN MOUNTING HOLE CENTERS | 0.995 INCHES MINIMUM AND 1.005 INCHES MAXIMUM |
| OVERALL HEIGHT | 0.785 INCHES MINIMUM AND 0.845 INCHES MAXIMUM |
| OVERALL LENGTH | 1.297 INCHES MINIMUM |
| OVERALL WIDTH | 0.265 INCHES MAXIMUM |
| MOUNTING FACILITY QUANTITY | 2 |
| MOUNTING HOLE DIAMETER | 0.086 INCHES MINIMUM |
| MOUNTING METHOD | UNTHREADED HOLE |
| POWER DISSIPATION RATING PER SECTION IN WATTS | 0.25 FREE AIR SINGLE SECTION |
| RELIABILITY INDICATOR | NOT ESTABLISHED |
| RESISTANCE TOLERANCE PER SECTION IN PERCENT | -20.0 TO 20.0 SINGLE SECTION |
| ROTARY ACTUATOR TRAVEL IN ANGULAR DEG | 7920.0 NOMINAL |
| SECTION QUANTITY | 1 |
| SHAFT DIAMETER | 0.110 INCHES MINIMUM AND 0.140 INCHES MAXIMUM |
| SHAFT LENGTH | 0.052 INCHES MINIMUM AND 0.062 INCHES MAXIMUM |
| SHAFT STYLE | ROUND, SLOTTED |
| TEMP COEFFICIENT OF RESISTANCE PER SECTION IN PPM PER DEG CELSIUS | -500.0 TO 50.0 SINGLE SECTION |
| TERMINAL LENGTH | 0.485 INCHES MINIMUM AND 0.515 INCHES MAXIMUM |
| TERMINAL LOCATION | RADIALLY POSITIONED OVER LESS THAN HALF THE CIRCUMFERENCE |
| TERMINAL TYPE AND QUANTITY | 3 PIN |
| TEST DATA DOCUMENT | 07573-933003107 DRAWING (THIS IS THE BASIC GOVERNING DRAWING, SUCH AS A CONTRACTOR DRAWING, ORIGINAL EQUIPMENT MANUFACTURER DRAWING, ETC.; EXCLUDES ANY SPECIFICATION, STANDARD OR OTHER DOCUMENT THAT MAY BE REFERENCED IN A BASIC GOVERNING DRAWING) |