| BODY HEIGHT | 1.780 INCHES NOMINAL |
| BODY LENGTH | 2.280 INCHES NOMINAL |
| BODY STYLE | W/MTG TABS/FLANGES, TERMINAL(S) ON ONE SURFACE |
| BODY WIDTH | 1.270 INCHES NOMINAL |
| CAPACITANCE VALUE PER SECTION | 10000.000 PICOFARADS SINGLE SECTION |
| CENTER TO CENTER DISTANCE BETWEEN TERMINALS PARALLEL TO LENGTH | 1.625 INCHES NOMINAL |
| DISSIPATION FACTOR AT REFERENCE TEMP IN PERCENT | 0.0010 |
| DISTANCE BETWEEN CENTERLINES OF MOUNTING FACILITIES PARALLEL TO BODY LENGTH | 2.625 INCHES NOMINAL |
| HIGHEST FREQUENCY AT WHICH RF CURRENT RATING APPLIES IN KILOHERTZ | 3000.0 |
| INSULATION RESISTANCE AT MAXIMUM OPERATING TEMP | 10.0 MEGOHM-MICROFARADS |
| INSULATION RESISTANCE AT REFERENCE TEMP | 7500.0 MEGOHMS |
| LOWEST FREQUENCY AT WHICH RF CURRENT RATING APPLIES IN KILOHERTZ | 100.0 |
| MATERIAL | PLASTIC CASE |
| MAXIMUM RF CURRENT RATING AT HIGHEST RATED FREQUENCY IN RMS AMPS | 11.0 |
| MAXIMUM RF CURRENT RATING AT LOWEST RATED FREQUENCY IN RMS AMPS | 4.3 |
| MOUNTING FACILITY TYPE AND QUANTITY | 2 UNTHREADED MOUNTING HOLES |
| NONDERATED CONTINUOUS VOLTAGE RATING AND TYPE PER SECTION | 2000.0 AC-PEAK SINGLE SECTION |
| NONDERATED OPERATING TEMP | -55.0 CELSIUS MINIMUM AND 85.0 CELSIUS MAXIMUM |
| RELIABILITY INDICATOR | NOT ESTABLISHED |
| SCHEMATIC DIAGRAM DESIGNATOR | NO COMMON OR GROUNDED ELECTRODE(S) |
| SPECIFICATION/STANDARD DATA | 81349-MIL-C-5/12A GOVERNMENT SPECIFICATION |
| TERMINAL DIAMETER | 0.190 INCHES NOMINAL |
| TERMINAL LENGTH | 0.469 INCHES NOMINAL |
| TERMINAL TYPE AND QUANTITY | 2 THREADED STUD |
| TEST DATA DOCUMENT | 81349-MIL-C-5 SPECIFICATION (INCLUDES ENGINEERING TYPE BULLETINS, BROCHURES,ETC., THAT REFLECT SPECIFICATION TYPE DATA IN SPECIFICATION FORMAT; EXCLUDES COMMERCIAL CATALOGS, INDUSTRY DIRECTORIES, AND SIMILAR TRADE PUBLICATIONS, REFLECTING GENERAL TYPE DATA ON CERTAIN ENVIRONMENTAL AND PERFORMANCE REQUIREMENTS AND TEST CONDITIONS THAT ARE SHOWN AS "TYPICAL", "AVERAGE", "NOMINAL", ETC.). |
| TOLERANCE RANGE PER SECTION | -5.00 TO 5.00 PERCENT SINGLE SECTION |
| UNTHREADED MOUNTING HOLE DIAMETER | 0.180 INCHES MINIMUM |