| ELECTRICAL ERROR ANGULAR RANGE IN MINUTES | -60.0 TO 60.0 |
| ACTUATOR FRICTION TORQUE AT MINUS 55 DEG CELSIUS | 2200.0 MILLIMETER-MILLIGRAMS NOMINAL |
| ALIGNMENT HOLE BOLT CIRCLE DIAMETER | 0.6750 INCHES MINIMUM AND 0.6810 INCHES MAXIMUM |
| ALIGNMENT HOLE DEPTH | 0.0625 INCHES MAXIMUM |
| ALIGNMENT HOLE QUANTITY | 3 |
| BODY MATERIAL | STEEL CORROSION RESISTING |
| BODY SIZE | 10 |
| BODY STYLE | STANDARD ROUND C |
| FLANGE DIAMETER | 0.9360 INCHES MINIMUM AND 0.9380 INCHES MAXIMUM |
| FLANGE THICKNESS | 0.0620 INCHES NOMINAL |
| FRAGILITY FACTOR | MODERATELY RUGGED |
| FREQUENCY IN HERTZ | 400.0 NOMINAL |
| OVERALL LENGTH | 1.5460 INCHES MINIMUM AND 1.5760 INCHES MAXIMUM |
| MAXIMUM TEMP RISE | 20.0 CELSIUS |
| MOUNTING SURFACE TO TERMINAL END DISTANCE | 1.2400 INCHES MAXIMUM |
| PILOT DIAMETER | 0.4995 INCHES MINIMUM AND 0.5000 INCHES MAXIMUM |
| PHASE SHIFT ANGLE IN DEG | 7.500 INPUT TO OUTPUT MAXIMUM |
| PILOT LENGTH | 0.0380 INCHES NOMINAL |
| RECEIVER ERROR ANGULAR RANGE IN MINUTES | -60.0 TO 60.0 |
| ROTOR INPUT CURRENT RATING | 142.0 MILLIAMPERES MAXIMUM |
| ROTOR INPUT ELECTRICAL POWER RATING | 620.0 MILLIWATTS NOMINAL |
| ROTOR INPUT VOLTAGE RATING IN VOLTS | 26.0 NOMINAL |
| SHAFT DIAMETER | 0.0895 INCHES MINIMUM AND 0.0900 INCHES MAXIMUM SINGLE SHAFT |
| SHAFT LENGTH | 0.3060 INCHES MINIMUM AND 0.3360 INCHES MAXIMUM SINGLE SHAFT |
| SHAFT SLOT DEPTH | 0.0250 INCHES NOMINAL SINGLE SHAFT |
| SHAFT SLOT WIDTH | 0.0200 INCHES MINIMUM AND 0.0250 INCHES MAXIMUM SINGLE SHAFT |
| SHAFT TYPE | ROUND, SLOTTED SINGLE SHAFT |
| SHOULDER DIAMETER | 0.8118 INCHES MINIMUM AND 0.8123 INCHES MAXIMUM |
| SHOULDER LENGTH | 0.0620 INCHES NOMINAL |
| SPECIFICATION/STANDARD DATA | 81349-MIL-S-20708/50 GOVERNMENT SPECIFICATION |
| ZSO-90 IMPEDANCE MAGNITUDE IN OHMS | 15.00 NOMINAL |
| ZSS IMPEDANCE ANGLE IN DEG | 15.000 NOMINAL |
| ZSS IMPEDANCE MAGNITUDE IN OHMS | 11.00 NOMINAL |
| TERMINAL LOCATION | REAR |
| TERMINAL TYPE AND QUANTITY | 5 WIRE LEAD |
| TEST DATA DOCUMENT | 81349-MIL-S-20708 SPECIFICATION (INCLUDES ENGINEERING TYPE BULLETINS, BROCHURES,ETC., THAT REFLECT SPECIFICATION TYPE DATA IN SPECIFICATION FORMAT; EXCLUDES COMMERCIAL CATALOGS, INDUSTRY DIRECTORIES, AND SIMILAR TRADE PUBLICATIONS, REFLECTING GENERAL TYPE DATA ON CERTAIN ENVIRONMENTAL AND PERFORMANCE REQUIREMENTS AND TEST CONDITIONS THAT ARE SHOWN AS "TYPICAL", "AVERAGE", "NOMINAL", ETC.). |
| TRANSFORMATION RATIO | 0.454 ROTOR TO STATOR NOMINAL |
| UNDERCUT DIAMETER | 0.8400 INCHES MAXIMUM |
| UNDERCUT WIDTH | 0.0620 INCHES NOMINAL |